Wiring | Drivers | Configuration
Capture cards are simple to configure but it can sometimes be difficult to determine the proper settings.
There are two possible ways to wire the capture card to the output of your surveillance video system. One option is to use an unused video output from your surveillance PC to send to the video capture card. The second option is to split the signal going to one of your monitors to send to the video capture card.
We recommend digital signals as they tend to be higher resolution which are better for facial recognition.
Blackmagicdesign DeckLink Mini recorder PCI Drivers should come with driver software new versions of the Desktop Video can be found here
Configure your capture card according to the specifications of the card. The information populated is retrieved directly from the capture card and may not necessarily make a lot of sense. Table 1 contains the normal capture card configuration if you are using an AverMedia digital capture card. If you are using another card, this configuration may be different.
- Log in to Visual Casino with the ability to search CID or SIN
- Select Search
- Select Add Facial Recognition Image
- From the top menu, select Capture Configuration (rightmost menu item)
- Enter the proper capture card configuration.
Table 1:Blackmagicdesign DeckLink Mini recorder Configuration
|Capture Device||Unknown - Blackmagic WEM Capture|
|Video Standard||Unknown - 30|
|Color Space Compression||YUY2|
Click on Video Proc
The most likely option to vary in this set of options is the Output Size. It will conform to whatever output resolution you configured for the monitor that you are mirroring to this output.
NOTE: In some cases the application may need to be Run as Administrator in order to persist the video capture settings following a reboot.